Power Distribution Module for Sniper 2 EFI Installations

Simply slide the stripped wire ends under the positive lock connector and tighten down the set screw.

It also distributes power to your EFI fuel pump and a single fan with built in relays (second fan can be ground triggered through the included input/output harness). Two additional 2-amp circuits can power low current accessories like gauges or to trigger relays.

***To use the PDM with Sniper 2 harness with included relay, simply terminate the relay to pump power wire and cut and route the trigger from the relay to the trigger on the PDM block***

Battery and a switched 12 volt source are all that's required from your vehicle to power the PDM.

Features:

Provides conditioned Power, Ground and Switched Connections for ALL components within a Sniper 2 EFI Install. (Throttle Body, Fuel Pump, HyperSpark Ignition System, and Optional Fan) 3 Relay Channels - 15A Powertrain (Sniper Throttle Body and Ignition System) 25A - Fuel Pump Output - 25A Fan Output LED status indicators, show you which channel is triggered at a glance Removable cover for easy accessibility, with wiring diagram built into the lid, like a fuel panel.